BUILD YOUR OWN BIG 3 3/0 WIRE KIT TO SUIT YOUR CAR OR TRUCK, YOU CONFIGURE IT WE BUILD IT PROFESSIONALLY FOR YOU TO SAVE YOU TIME .

• • 3/0 EXCELENE WELDING CABLE
  • CONDUCTORS:BARE COPPER
  • STRANDING:1615
  • JACKET: EPDM
  • AMPACITY:500
  • O.D:.635
  • TEMPERTURE: -50*C TO 105*C
  • VOLTS:600V HIGH DIELECTRIC STRENGTH INTEGRITY
  • RESISTANCE TO FLAME,OIL,GREASE SOLVENTS,OZONE AND ABRASION,(ROHS COMPLIANCE)
  
  
  EACH CABLE CAN BE COVERED IN A PET PROTECTIVE BRAID MADE TO WITH STAND 125+C HEAT EXCELLENT FOR ENGINE COMPARTMENTS.
  
  EACH CABLE IS HYDRUALIC CRIMPED AND PULL TESTED FOR CRIMP DURABILITY.
  
  EACH END OF THE CABLES ARE SEALED WITH DUEL WALL 3:1 GLUE HEAT SHRINK FOR THAT ULTIMATE SEAL.
  
  EACH LUG IS MADE OUT OF COPPER AND IS TINNED FOR CORROSION RESISTANT PROTECTION.
  
  
  THESE CABLES ARE MADE IN THE USA AND IS MADE OUT OF PURE COPPER.
  
  
  
  
  
  

$12.99 IS FOR LABOR COST TO BUILD THESE CABLES PROFESSIONALLY WITH THE PROPER TOOLS FOR CRIMPING THE LUGS AND HEATING DOWN THE DUAL WALL HEAT SHRINK. A LOT OF PEOPLE USE A HAMMER ON LUG CRIMPER WHICH IS FINE IF YOU WANT A CHEAP GET YOU BUY CRIMP. WE CRIMP ALL OUR CABLES WITH A HEXAGON CRIMPER BY MOLEX WHICH CRIMPS THE LUG ON ALL SIDES. ALSO THE CABLE WE USE IS MADE IN USA AND IS MADE OUT OF PURE COPPER. THERE'S A LOT OF WIRE AND CABLE ON THE INTERNET THAT IS MADE OUT OF CCA WHICH IS (COPPER CLAD ALUMINUM) TRUST ME YOU DO NOT WANT THAT RUNNING IN YOUR CAR. ALSO THERE'S A LOT OF TALK GOING AROUND ABOUT 0 GAUGE WIRE, WELL IN THE AWG-AMERICAN WIRE GAUGE 0 GAUGE WIRE IS REFERRED TO AS 1/0 OR 0. HERE'S THE THING ABOUT 0 GAUGE. WHEN READING WIRE AND AWG SIZE'S THE BIGGER NUMBER MEANS IT'S A SMALLER DIAMETER EXAMPLE 24 AWG IS NOT BIGGER THAN 2 AWG IT'S THE OTHER WAY AROUND 2 AWG IS BIGGER THAN 24 AWG WIRE. THEN IT GOES INTO THE AUGHT SIZE'S LIKE 0 IS 1/0, 00 IS 2/0.000 IS 3/0 AND 0000 IS 4/0.WELL NOW IF YOU LOOK AT HOW THE AWG CHART IS LAID OUT CAR AUDIO O GAUGE IS ABOUT AS BIG AS 2/0 WELDING CABLE BUT ON THE CHART IT'S BELOW 1/0 AND 1 AWG IT'S IN THE BETWEEN SO HOW CAN IT BE AS BIG AS TRUE 2/0 WELDING CABLE.. IS IT BECAUSE IT'S A MADE UP PRODUCT OF CHINA AND IT'S MADE OUT OF CCA WIRE OR TINNED COPPER WIRE.. I DON'T KNOW ..BUT DON'T LET THE HYPE FOOL YOU. THE OTHER GUY'S BIG 3 KITS HAVE A PVC JACKET. THAT TYPE OF JACKET IN A ENGINE COMPARTMENT WILL PROBABLY GET HARD AND BRITTLE OVER TIME, WHICH IS NOT GOOD FOR YOUR AMP OR SYSTEM. THE REASON I AM WRITING ON THIS IS BECAUSE OF ALL THE TALKS ABOUT THIS O GAUGE AND PEOPLE NOT REALLY UNDERSTANDING WHAT THE DIFFERENCE IS ABOUT THE WIRE. I KNOW IT LOOKS GOOD UNDER THE HOOD OF THE CAR BUT DOES IT REALLY PERFORM HOW IT SHOULD. WELL GO TO YOUTUBE AND TYPE IN CCA VS COPPER. THIS WILL SHOW HOW CCA WIRE PERFORMS. JUST CHECK IT OUT...THIS IS JUST REFERENCE.